? for those w/ Pro-M 77's

J

j rick kirby

Guest
Is there an intake tube that we can use other than the one that comes w/ the meter?I am using the foot they sent and have built an air box and ram air set up also.
 
What do you mean intake tube? Pro-M MAFS are calibrated at the factory so if you mean the sampling tube, no. There is only the one tube.

You can send your entire intake piping back to them and they will, for a fee, flow test the whole intake system and perfectly optimize the electronics.
 
I don't think there is another intake tube besides that one that comes with the unit that will fit. It is the one that is like a funnel, big at one end near the MAF and smaller at the other end at the TB. Pro-M does make another tailpiece for that MAF that will take a 3" or 3.5" metal intake with the rubber hoses. I actually had my machinist cut down the tailpiece I had so it would fit my custom intake tube.

I also found a place that made an adapter so I could run a different air filter as well.

swbengine3.jpg
 
Back
Top