Help needed with CHIP !

fstcoupeT.O

Registered User
Recently got a chip for my 1990 SC. Wondering if anyone has run into a issue like this......finally managed to get the ECM out put in the chip after much cleaning etc...as per the instructions in the package. Engine will not start. I requested some cooling mods and as such with the ignition switch in the on position the fan immediatly starts....what do i need to do to get the damn thing to start....as you can see i am getting very frusrated....

Please HELP !!!
 
Check the contacts on the chip and also make sure you bolted the connector for the EEC up there properly. Inspect all the pins when you take it back apart to make sure nothing is bent.

The chip should have come with a little scrubby pad to help you clean the contacts. Use it. There are contacts on both sides and they need to be spotless.
 
Back
Top