5 lug conv parts ford racing

ndoftyme69

Registered User
would these work for coverting the rear to the 4.5 bolt circle. found them on the ford racing website says for kit car with IRS.

the kit car knuckle set which is needed for the hub is original equpiment on 89-97 thunderbirds and 93-98 mark 8's
http://www.fordracingparts.com/parts/part_details.asp?PartKeyField=7828

i would need to purchase the bearings which is also original equipment on the same vehicles listed above. but i would need new ones.
http://www.fordracingparts.com/parts/part_details.asp?PartKeyField=7818

the kit car IRS hub is original equipment on the 99-04 cobra and is said to be used with the kit car IRS knuckle which is the original equipment on our cars.
http://www.fordracingparts.com/parts/part_details.asp?PartKeyField=8397

so all i would need to do is buy the bearings and the hubs and have my stock rotors redrilled???
 
Conversion Parts

The hub and bearings listed for the rear will work just fine, but you can't use the front brakes that are shown they are for a fox bodied car. All you need for the front is the hubs from a 94-04 Mustang and either redrill your rotors or use the front brakes from the same year Mustang. On my Car I used the stock rear caliper with a relocation bracket from Fast Ed and Cobra rear rotors and on the front I have the 2000 Cobra R Brembo setup.

Charles
 
Back
Top