PDA

View Full Version : dyno run



nickleman60
03-04-2006, 12:11 PM
i went to steen this morning to see what the old blackbird has.my best pull was 233.13 rwhp and 328.63 torque.it wasn't quite as good as i was expecting but without a chip and tune i guess it was ok.my hp curve was pretty flat across the graph between 3600 rpm and 5000 rpm so it's good it didn't fall off in hp in the upper ranges.air/fuel ratio stayed between 12/1 and 10.8/1.next visit to steen will be for a chip and tune with a double i/c,mp inlet and nitrous installed.hopefully that'll put me over 300 rwhp.

z90sc
03-04-2006, 03:22 PM
.....just where we thought it would be,huh......looking forward to seeing the improvement with the mods........you're gonna make me spend more money aren't you!;)
z

mcate
03-04-2006, 07:03 PM
.....just where we thought it would be,huh......looking forward to seeing the improvement with the mods........you're gonna make me spend more money aren't you!;)
z

You just might have to put those Coy Miller heads on soon!

pablon2
03-04-2006, 09:26 PM
i went to steen this morning to see what the old blackbird has.my best pull was 233.13 rwhp and 328.63 torque.it wasn't quite as good as i was expecting but without a chip and tune i guess it was ok.my hp curve was pretty flat across the graph between 3600 rpm and 5000 rpm so it's good it didn't fall off in hp in the upper ranges.air/fuel ratio stayed between 12/1 and 10.8/1.next visit to steen will be for a chip and tune with a double i/c,mp inlet and nitrous installed.hopefully that'll put me over 300 rwhp.


What are your mods?

BIG4CAM
03-04-2006, 10:13 PM
.....just where we thought it would be,huh......looking forward to seeing the improvement with the mods........you're gonna make me spend more money aren't you!;)
z
ISN'T IT FUNNY HOW EVERYONE SAYS THE SAME THING? HORSEPOWER IS ADDICTING, JUST WAITING FOR THEM TO COME OUT WITH THE HORSEPOWER PATCH LIKE THE NICOTINE ONE AND ILL BE SET!!!

nickleman60
03-05-2006, 12:03 AM
pablon my mods are 76mm c&l maf,75mm tb,ported intake plenum,10% sc pulley,mac cai,mp raised top,i/c fan and shroud,2 1/4" cat delete downtubes,scp big dog exhaust cloned,3.73 trac loc