Need help with vacuum diagrams

redtbirdsc

Registered User
I used the searc but it didnt help me too much so here goes. I installed a mp II blower, inlet and all the other goodies on my 91 sc but have a little problem with all the vacuum lines.Any have a pic or something of where the lines go? and do i still use the stock peice that comes up from the pcv?

Thanks
chris
 
you will have to reroute all your vacuum lines with the MP inlet, ditch all the factory formed hoses. I will take some pics tom and show you what I came up with. Takes brass fittings, 1/4 hose, and 3/8 hose. Not to bad at all.
 
heres some pics. I made the brass section to run the pcv valve and the evap emissions hose coming from the passenger side, assembles as follows from the MP inlet install 1/4 close nip, then a t-fitting facing driver side with 3/8 barb, on end of T fitting install a 1/4 90 deg. with a 1/4 barb. The bottom 2 ports are running the cross talk hose and the brake vacuum hose. Hope this helps
 
Last edited:
Back
Top