PDA

View Full Version : motor mounts



chazzwozzle
06-22-2006, 02:05 PM
well im instaling a set of solid rubber motor mounts. i have all the front accessories including upper and lower ic tubes out of the way. i have a pretty clear view of both mounts from the front now. does any one know how many bolts hold the mount assemly on, on each side? and will i have to remove any bolts from the bottom or can i get them all from the top. car is a 90 5 speed

AnnivSpeCpe
06-22-2006, 03:05 PM
jack up engine to take pressure off the mounts. Then remove the horozontal through bolt, it unscrews from the front (there is no nut it just screws into the mount). There is one bolt that bolts straight down on the drivers side only that has to be removed. Then there are three bolts that secure the upper part of the mount to the block on each side. All can be removed from the top as I just did it. Remember to reattach the ground strap on the mounts. John