PDA

View Full Version : Need info on VMM question



AnnivSpeCpe
06-22-2006, 03:57 PM
I'm swapping in a 94SC engine into my 90SC. I really dont want to swap the oil pans just to retain the oil level sensor. If I didn't connect up the sensor what would be the issue indicated at the VMM? Would I be looking at a "low oil" message all the time. If so, what would it take to deactivate the low oil sensor? Thanks, John

90coug
06-22-2006, 05:40 PM
This I'm not sure about but I'm guessing if you don't hook it up and you do get a CEL I bet you can jumper two of the wires on the connection to get rid of it. Worse case you can put a small black sticker over the low oil light, lol



Curious myself if there is a better solution:confused: