View Full Version : looking for roller rockers

06-29-2006, 07:32 PM
hey everybody does anybody know a good web site where i can find rockers??? iv looking and looked and found nothing:mad: thanks

06-29-2006, 08:12 PM
You did't check : http://www.supercoupeperformance.com

Check with these folks as well. They may not list it but they may be able to get some:

And finally, I know this guy can get them as I'm getting some from him. Send him an e-mail for info as he doesn't have a website

06-30-2006, 03:44 AM
I've got a set from Dave Dalke. They're top quality and I have no complaints. I must caution though, if you buy them...measure for new pushrods before you go slapping it together. Too little preload on the lifters and they'll be slapping around, too much preload and the valves are going to hang open.

06-30-2006, 07:43 AM
I know of:
1- Morana (cool anodized copper color...not sure if these are 'scorpion' ones)
2- Ford motorsports (cool anodized blue ones)
3- Blue tongue (polished aluminum look)

Plus as mentioned above D Dalke, and i know i've seen somebody who put some cool anodized red ones in their engine...but not sure who makes those. As long as they're 351C pedestal mount ones you can use them. I've got the motorport ones.

07-01-2006, 03:25 AM
The only copper colored ones I've been able to find are the ones from Harland Sharp. These are awesome rockers, but for the price...you can probably buy some other parts first.