Plug size near water pump/behind alternator

pablon2

Registered User
There is a plug (looks like 1/4", but I'm sure it is not as it is metric) at about the 2:00 position as you look directly at the water pump. It is directly below where the DIS would be and behind the alternator. I'd like to try hooking an oil pressure sender to that port. Anyone know the size and pitch of it? Do you think my odds are slim to none of finding an adapter that goes from metric to 1/8" NPT?
 
The DIS Module is on the pass side on top of the a/c bracket. However, the coil pack is behind the alternator.

The only port that I can think of anywhere near that area is the stock oil pressure gauge port. There should be the stock sender on the end of what looks like a short pipe. It is 1/4"NPT....by the way, an NPT fitting is tapered and thus you cannot just screw in a standard fitting/bolt into it.

Aside from that....I'm not sure which port you're talking about.
 
Back
Top