Looking for some advice, pictures, direction here guys.
Here's the deal, a short while back, I installed a double IC, which has performed flawlessly. But, as many of you may know, Lining up all of the piping w/ a DIC is a pain in the ~~~. I have an idea to use a silicon coupler to replace the spanner nut connection. This would make it much easier to connect in the future, as it'll give you a little bit of play. I know this has been done before, but I'm not sure on how to go about it?
Do I need to get a new top without a flange on it? Can I just cut the spanner nut and flanges off and slap a silicon coupler on?
I recently saw a pic of someones engine posted on here where they had what looked to be a flexible silicone coupler, but now I can't find it to ask where they got it from...searching didn't help.
Any info, suggestions, or advice is more than welcome. Thanks.
-Trey
Here's the deal, a short while back, I installed a double IC, which has performed flawlessly. But, as many of you may know, Lining up all of the piping w/ a DIC is a pain in the ~~~. I have an idea to use a silicon coupler to replace the spanner nut connection. This would make it much easier to connect in the future, as it'll give you a little bit of play. I know this has been done before, but I'm not sure on how to go about it?
Do I need to get a new top without a flange on it? Can I just cut the spanner nut and flanges off and slap a silicon coupler on?
I recently saw a pic of someones engine posted on here where they had what looked to be a flexible silicone coupler, but now I can't find it to ask where they got it from...searching didn't help.
Any info, suggestions, or advice is more than welcome. Thanks.
-Trey