cam ? need help

ZOOMBUGGY3

Registered User
im looking at buying a cam off someone. the cam specs are .535int/.548ext he told me to use 7.192" push rods but he is not sure on the springs can some one help me out on this. and do i use 1.73 ratio rockers or 1.8. i was hopping if some of you top dogs can help me out.you guys help me out alot in the past so i was hoping that you guys will help me again.thank in advanced.
 
If you want something faster you'll need to give the folks a call. Your best bet is to call who ever ground that cam and see what they suggest. It's likely Comp or Crane cams that did the work. Push rod length could be variable. I'd suggest a adjustable push rod thing that lets you figure the exact pushrod length ya need.
 
If the rest of your valvetrain hardware is stock then Crane 96803's will work ok. There are plenty of other options if you get into it deeper but then you have to buy specific parts and have specific machine work done.
 
Back
Top