Building up Motor

OneFastBird

Registered User
I should be putting my motor together here in the next couple of weeks for my 94 5-speed and I just want to make sure that I build it up right(so that the motor stays intaked) and taking a few runs down the drag strip once in awhile. I've just purchased spinning-wheels stage 1a cam and ported matched heads. I have the following mods, 80mm mafs, 3.5" intake, 85mm t-body, mp inlet, s-model, inlarged sc top, fmic, 5% sc pulley, underdrive pulleys, headers, and full exaust. I'm about to get 50lb injectors. Is there anything else that I should do to the car, I'm not looking to make it faster, just want to replace anything that will need replaced to keep my car from breaking down. Thanks
 
bigger fuel pump to keep up with those injectors also go with the BHJ aftermarket balancer.
 
Last edited:
Machine heads & block decks to a 60r finish.
And then use 1998 mustang 3.8 COATED MLS
head gaskets. www.rockauto.com
part number 297 9263PT & 297 9262PT.

They cost around $120.00

Randy
 
Last edited:
Back
Top