Engine specs

'93 shop manual says:

Crankshaft Bearing Bore Diameter
61.635mm-61.655mm
2.4266in-2.4274in

there's also numbers for center to center lenght; piston pin taper limit; alignment (bore to bore max diff) TWIST & BEND; side clearance (assembled to crank.
 
ZStang said:
What's the B.E. (Big end) width of connecting rods of our engines?
Click to expand...


That was a good question and the info wasn't easy to find in the Helm manual, but I finally found what you want. There isn't a big end width spec given per se, but a total assembled clearance. The assembled dimensions are
.0047 min to .0114 max desired clearance. Absolute max limit is .014. Hope this helps. John
 
You must log in or register to reply here.
Back
Top