PDA

View Full Version : Got a deal on this intercooler "FREE"



Jeremy_K
11-14-2006, 08:48 PM
I pulled this intercooler off of one of our work trucks that is going to scrap. When I got it off I noticed that the inlet and outlet are rather small. 1 3/4" but the core is pretty big and it's well constructed with an ACT sending unit already installed. Do you think it could be used for a FMIC project??????
Here's a link to one on fleabay.
http://cgi.ebay.com/MITSUBISHI-FUSO-ISUZU-NPR-TOYOTA-HONDA-USED-INTERCOOLER_W0QQitemZ150059410088QQihZ005QQcategor yZ38634QQssPageNameZWDVWQQrdZ1QQcmdZViewItem

Young-SC-Owner
11-14-2006, 10:50 PM
whats an ACT sending unit?

Jeremy_K
11-14-2006, 11:12 PM
air charge temp.

89SCK@t
11-15-2006, 12:45 AM
I would use that one before I bought an aftermarket type. I would venture to say that those ones are built to withstand 20-40psi of boost for prolonged periods, stoplight-to-stoplight, and city traffic. In theory they shouldn't be as prone to heatsoak as the stock IC.

Jeremy_K
11-15-2006, 01:07 AM
I'm just a little concerned about the small inlet and outlet. They are only 1- 3/4" I.D. Does anyone know the inside diameter of the stock intercooler inlet and outlet?

XxSlowpokexX
11-15-2006, 01:39 AM
You can always cut and weld!..do a search..I think this ic has been talked about before

Jeremy_K
11-15-2006, 04:41 PM
You can always cut and weld!..do a search..I think this ic has been talked about before

No luck with the search. Others have used the isuzu NPR intercooler which has wider inlet and outlets.

darkstar_one
11-15-2006, 05:13 PM
yeah just have the end tanks cut off and some bigger ones welded on... and pressure tested of course, good find