ShawnSC1
Registered User
I am installing a used engine in my XR7. It runs great. But there is a few things that I have to do.
I have to change both rocker arm cover gaskets. Would there be a right way of installing the gaskets or is it just clean ect. , and the same thing with the oil pan gasket. Just wondering if I should use a seal or not.
My SC is leaking around the pulley. Is there a seal behind the pulley and if there is it easy to change. I pulled off the SC Adapter. I guess I would use a seal not a gasket and the same with the tubes.
Also what is the best oil and grade that is good to use and the same with the tranny. Before I used a cheap oil and 10w-40.
The reason why I am asking these stupid questions, is because I banged 2 engines. I would like to be safe on the thrid engine. If you have any hints on what I should do on any of this. Please let me know. Thanks
I have to change both rocker arm cover gaskets. Would there be a right way of installing the gaskets or is it just clean ect. , and the same thing with the oil pan gasket. Just wondering if I should use a seal or not.
My SC is leaking around the pulley. Is there a seal behind the pulley and if there is it easy to change. I pulled off the SC Adapter. I guess I would use a seal not a gasket and the same with the tubes.
Also what is the best oil and grade that is good to use and the same with the tranny. Before I used a cheap oil and 10w-40.
The reason why I am asking these stupid questions, is because I banged 2 engines. I would like to be safe on the thrid engine. If you have any hints on what I should do on any of this. Please let me know. Thanks