Flush Power Steering Fluid

Pat

Registered User
Apparently my dad added the wrong power steering fluid & atm its brown & murky.
 
Assuming you are asking how to flush it.

Disconnect the coil pack connector so the engine will not start. Get the car up and disconnect the flexible hose from the LP hardline at the front of the subframe cross member. Bump the starter while adding fluid until you get clean fluid coming out turning the wheel as you go back and forth. Reconnect the LP flexible hose. Top off the fluid level. Do not overfill. Reconnect the coil pack connector. Start the car and turn the steering wheel back and forth. Recheck fluid level and correct as required. Lower the car back to the ground. At least this is the way I did it.
 
Back
Top