OK, now I'm putting the SC engine back in after a rebuild,
getting close to finished, but, have a few 'loose ends', so to speak, like;
where does the sub-harness for the knock sensor and RH O2 sensor
run, to plug in to the main engine harness?
Its a little square gray plug, can't remember, or find, where it runs to;
can't find a pic in either Haynes or Helms manuals,
[its prolly in Helms, somewhere, everything is in there;
i just can't ever find anything when i need it].
Also, I'm having trouble getting the lower IC tube in position to bolt to the LH bracket,
seems to be hung up on power steering hoses or something;
Should these be routed under it, or what?
Thanks in advance, SC Gurus.
getting close to finished, but, have a few 'loose ends', so to speak, like;
where does the sub-harness for the knock sensor and RH O2 sensor
run, to plug in to the main engine harness?
Its a little square gray plug, can't remember, or find, where it runs to;
can't find a pic in either Haynes or Helms manuals,
[its prolly in Helms, somewhere, everything is in there;
i just can't ever find anything when i need it].
Also, I'm having trouble getting the lower IC tube in position to bolt to the LH bracket,
seems to be hung up on power steering hoses or something;
Should these be routed under it, or what?
Thanks in advance, SC Gurus.