ok i havent done any research on what injectors or anything i should run with my motor....
89 SC block bored 30 over
stock forged crank
stock "forged" rods
forged 30 over pistons
ported heads
gasket matched intake
~15lb m90 dont exactly know yet
ported IC tubes
double IC
ported headers
2.5 straight pipes
i was thinking 50lb but i dont know
and if i replace my injectors with 50lb what do i have to do to the fuel rail, lines,FPR, pump, ect.
hehe and while were on fuel what octane should i run.... i heard i should run 89 or better ALWAYS..... i ran 87 in my SHO and it studdered alot... dont want that in the SC
89 SC block bored 30 over
stock forged crank
stock "forged" rods
forged 30 over pistons
ported heads
gasket matched intake
~15lb m90 dont exactly know yet
ported IC tubes
double IC
ported headers
2.5 straight pipes
i was thinking 50lb but i dont know
and if i replace my injectors with 50lb what do i have to do to the fuel rail, lines,FPR, pump, ect.
hehe and while were on fuel what octane should i run.... i heard i should run 89 or better ALWAYS..... i ran 87 in my SHO and it studdered alot... dont want that in the SC