How Do I Replace The Sc Pulley

wingzeroac195

SCCoA Member
Hey guys, I just got a 10% for the supercharger, and I want to know what do I need to replace this pulley and how to do it, any ideas?:confused:
 
1) Loosen and remove SC shaft nut before removing belt (regular RH thread).
2) Remove SC belt.
3) Remove upper radiator hose and thermostat housing.
4) Use appropriate 3-jaw puller to remove pulley.
 
all i did was take the nut off and use a gear puller and it came right off

Well, you might be able to work around the thermostat housing with the right puller; I couldn't with mine. But, the belt has to come off for sure...

JD
 
Well, you might be able to work around the thermostat housing with the right puller; I couldn't with mine. But, the belt has to come off for sure...

JD

i dont know, maybe you do need to. i just took the pulley off the blower when it was off the car
 
Well of course its easy when its off the car. :D

I pulled the SC pulley off while it was on the car. The water outlet pipe gets in the way of the 3 jaw puller I used. I had to manuever it a certain way and re-configure the puller, but I was able to do it without removing the outlet pipe.

- Dan
 
Rather than mess with the water thermostat housing,
I undid the 3 bolts that hold the blower down,
and lifted the snout, then used 3-jaw puller.
 
Back
Top