metanoiadude
Registered User
my head gaskets have gone. when i start the car and get on the gas (into boost) blows my radiator fluid out of the resivoir. i have already purchased an upper gasket set from scp but was wondering, do the heads require plaining or is that a recomendation? i am probably going to get them plained anywaysjust to make sure there flat and not warped. also when the heads are plained that will make the combustion chamber a lil smaller b/c of the metal taken off the head to make it flat, do i need to do anything special b/c of this raised compression or is it such a small amout i dont need to worry about it? just a couple things i would like to know before i jump in and start tearing things apart.
thanks
thanks