PDA

View Full Version : Weld Draglites mounted

V6Sprout
03-30-2007, 11:34 PM
Finally got some wheel spacers for the front draglites to clear the PBR calipers, so I can finally get all 4 draglites on the car, instead of just the rears. Car loks mean even though it has an unpainted body kit, yeah I know I'm a ricer, at least its not a ricer body kit :)

http://www.mustangmods.com/ims/u/425/1485/156615.jpg

http://www.mustangmods.com/ims/u/425/1485/156616.jpg

http://www.mustangmods.com/ims/u/425/1485/156617.jpg
91 5.0 sc
03-31-2007, 08:29 AM
Hey thats not a sc :D look good man it will look better when you paint the ground effects:)
Jason Wild
03-31-2007, 09:22 AM
Did you end up using a spacer thats all had to do to clear cobra calipers
Payton
03-31-2007, 10:23 AM
Did you end up using a spacer thats all had to do to clear cobra calipers

Jason, I believe he mentioned spacers in his post:
Finally got some wheel spacers for the front draglites to clear the PBR calipers
V6Sprout
03-31-2007, 12:37 PM
its not an SC but it does have an SC motor :) So its half SC.

I have the PBR calipers from the 99 V6 stangs which require spacers to run draglites, but Iknow they will also clear cobra brakes as well, since i know someone who has the same spacers and runs draglites on his Cobra.
Jason Wild
04-02-2007, 08:20 PM
Jason, I believe he mentioned spacers in his post:

Good to see your still want to point stuff in my posts.

What I was meaning did he just use spacers or ones with another set of bolts in them so the studs will be longer to meet spec drag racing.
V6Sprout
04-02-2007, 10:43 PM
I am using spacers that bolt to my existing studs and the spacers ahve a new set of studs on them. The new studs are the same length as factory studs which don't go through the entire rim due to thethickness of the center section on weld rims. I am currently using shanked lugnuts, but I do have longer studs for the spacers which I will put on eventually.