Koni Yellow Inserts

Toms-SC

Registered User
Hey,

Is there any better directions then the ~~~~ that is included with them from the factory? Any tips to installing them? Thanks
 
I don't think there is any better instructions at least I didn't find any when I was looking for some.I just did mine about a week ago and I put a hose clamp around the strut to use as a guideline.I put it a little below where the strut tapers to the full size then used a cut-off wheel to make the cut.Once I had it cut I used a file and some sandpaper to dress the cut.Then remove the shaft and inner valve assembly and drain and clean up the inside with some brake cleaner.Then just use a center puch to give you a place to drill you're bottom hole and drill it to size.And you're done it only took me 20 or 30minutes to modify both sides.

Jay
 
Back
Top