Hi Folks;
Well I figure I'm about 1 hour away from firing up my 95 SC which I bought dead and have put a rebuilt 3.8 into.
One nagging question, when I put the wiring harness back, I wasn't entirely sure how to determine the order of the wires going to the injectors. Obviously, cylinder 1 and 4 are simple 'cause their far apart, but 2, 3 and 5,6 were not obvious and I had to 'guess' based on wire patterns. So how do I determine the correct wire for each injector? What should I expect upon startup if the order of the aforementioned cylinders is incorrect?
Thanks for your help, I should be running after 6 months of rebuilding, within the next couple of days!
Well I figure I'm about 1 hour away from firing up my 95 SC which I bought dead and have put a rebuilt 3.8 into.
One nagging question, when I put the wiring harness back, I wasn't entirely sure how to determine the order of the wires going to the injectors. Obviously, cylinder 1 and 4 are simple 'cause their far apart, but 2, 3 and 5,6 were not obvious and I had to 'guess' based on wire patterns. So how do I determine the correct wire for each injector? What should I expect upon startup if the order of the aforementioned cylinders is incorrect?
Thanks for your help, I should be running after 6 months of rebuilding, within the next couple of days!