AOD Tranny building

THE BIRDMAN

Registered User
Is an AOD tranny very hard to rebuild?I've built a few trannies before just never a AOD.I built a few th-350's torque flight 727's etc.So is there any special quirks to building an AOD.I was looking at getting a lentech valve body and a harden inner input shaft.Also looking to get a rebuild kit not sure from what company but I was thinking of one with red alto clutches and kolene steels.What everyone's thoughts.


Jay
 
I think they are easy transmissions. Like everything else it's a matter of learning the tricks. Avoid alto like the plague.
I don't know of any kits that have everything you need I have to buy parts from this and parts from that to make a good combination. You need to know which internals you have as well, you may need to change some of them.
Alan
 
Alan I pm'd ya(looking for more info).Also what's so bad about alto's I've ran them in a couple th-350's with good results.Or did I just get lucky?



Jay
 
Back
Top