Snout to rotor pack seal?

Mercutio

SCCoA Member
I disassembled a spare blower tonight to swap the rotor pack and snout over to my new MPX case. Dumb question time--when I took the old blower apart, there was no silicone or anything between the snout assembly and the rotor pack. Do I need to add silicone when I rebuild, or is the torque spec just ridiculously tight?
 
use a tube of GM Gasket Maker #1052942, draw a new gasket out on the supercharger. Tighten the snout down replacing the 7 bolts using a 10mm socket. Tighten to 15ft/lbs.
 
Back
Top