fastsc92
Registered User
i was just driving my car and the check engine light came on....then went off. I went into the local store...came back out started the car and the light came on again. Then i realised i didn't have any tach reading. it was at 0. so i went to my friends house who has a scanner to pull the codes. on the way there it was fine...perfect in fact, but when i went to his house and tryed to start it to run the scanner it wouldn't start. I cranked it so many times. after about an hour we got it to run and pulled 2 codes. 212(Loss of ignition diagnostic monitor (IDM) input to EEC precessor/SPOUT circuit grounded) and a code 214 (Cylinder Identification (CID) ciruit failure). I ended up having to drive the car home...just barely. I ran every red light on the way. The car doesn't want to idle, so i had to stay on the gas. but the car runs perfect when its going. i cant figure this out, and the thing that sucks its....school starts tomrrow and i dont have a ride. Pain in the ass. If anyone could please help me out on this one....it would mean so much to me. Thanks alot guys...i can always count on you.