PDA

View Full Version : A/C Clutch Pulley



livn
08-28-2002, 11:51 PM
Anyone know how to remove this pulley (runs off of AC compressor)? Theres a screw in the middle that pops the cluth off but i cant seem to figure out how to get the pulley off. Should it just pop off once the screw is removed or is there something else holding it on?

TbirdSCFan
08-29-2002, 01:31 AM
There's a snap ring holding the pulley on. The right and easiest way to do it is to use snap ring pliers.. The "hack" way is with a couple of small flat tip screwdrivers which you use to walk it off. When it gets there it will usually go flying off somewhere so be sure to catch it before it falls into an impossible to reach part of the engine compartment.