007_SuperCoupe
Registered User
I'm working on a personal project and need some information on the pulleys on the Super Coupe.
Basically what I need is this: (I'm not worried about the accessories, just the supercharger drive information)
Crank pulley diameter (stock to jackshaft):
Crank pulley diameter (10% to jackshaft):
Jackshaft pulley diameter (Stock from crank):
Jackshaft pulley diameter (5% from crank):
Jackshaft pulley diameter (10% from crank):
Jackshaft pulley diameter (Stock to supercharger):
Jackshaft pulley diameter (5% to supercharger):
Jackshaft pulley diameter (10% to supercharger):
Supercharger pulley diameter (94/95):
Supercharger pulley diameter (89-93):
Supercharger pulley diameter (5%):
Supercharger pulley diameter (10%):
Basically I'm working on a spreadsheet where I can enter some basic information and it will calculate the drive ratios of the supercharger. This is done more for custom applications like M112s, AR, etc so that you can get the right pulley combination for your engine requirements. I'm sure someone will be able to just say it's 2:1, but that's not what I want. I want to be able to calculate the ratio given a specific pulley size. So I need the pulley size information to build a table in order to extract the data. I would also prefer accurate measurements, not approximations. The more accurate the data, the better the calculator will be.
Thanks for the information.
Basically what I need is this: (I'm not worried about the accessories, just the supercharger drive information)
Crank pulley diameter (stock to jackshaft):
Crank pulley diameter (10% to jackshaft):
Jackshaft pulley diameter (Stock from crank):
Jackshaft pulley diameter (5% from crank):
Jackshaft pulley diameter (10% from crank):
Jackshaft pulley diameter (Stock to supercharger):
Jackshaft pulley diameter (5% to supercharger):
Jackshaft pulley diameter (10% to supercharger):
Supercharger pulley diameter (94/95):
Supercharger pulley diameter (89-93):
Supercharger pulley diameter (5%):
Supercharger pulley diameter (10%):
Basically I'm working on a spreadsheet where I can enter some basic information and it will calculate the drive ratios of the supercharger. This is done more for custom applications like M112s, AR, etc so that you can get the right pulley combination for your engine requirements. I'm sure someone will be able to just say it's 2:1, but that's not what I want. I want to be able to calculate the ratio given a specific pulley size. So I need the pulley size information to build a table in order to extract the data. I would also prefer accurate measurements, not approximations. The more accurate the data, the better the calculator will be.
Thanks for the information.