quicktsi
Registered User
I pulled off the DIS and cleaned off all the old go which was still a little tacky. I also cleaned off all the old go on the mount. I installed a thin layer of the Artic Silver 5 which I got from CompUSA for 9.99. The instructions say it may take 200 hours to set up.
So far it does not seem to start any faster. I drove it for about 30 minutes and did notice I did not have any tach drop out. The others that have done this did you notice an immediate difference in start up?
I have always thought it started like it may have a vac leak or an worn out fuel pump? The next idea is to replace the cam sensor and do a boost leak test. I have pictures that I will post up tomorrow.
So far it does not seem to start any faster. I drove it for about 30 minutes and did notice I did not have any tach drop out. The others that have done this did you notice an immediate difference in start up?
I have always thought it started like it may have a vac leak or an worn out fuel pump? The next idea is to replace the cam sensor and do a boost leak test. I have pictures that I will post up tomorrow.