Fmic ?

sccrewzer

Registered User
I just got my IC the thing is the inlet and outlet are 2.5 inches I read somewere in these forums that the ideal size tubing was 3 inches. My question is do you guys think its wise to put 3 inch tubing and reduce it at the IC connection to 2.5 or is it ok to run 2.5 all the way.:confused:
 
I think 2.5 all the way will be fine and easier to route. I've never seen where 3" was said to be the best if/when I do my fmic I'll be using 2.5 for it all. Plus it mates up well with the sc top exit.
 
I also used 2.5. Havent got it runnin yet to say its good.

But would think if you go to big and cant push the air fast enough you may have a lag. Not even sure if superchargers have lag like turbos:confused:

I was able to fit 2.5 with keeping my a/c and no cutting to the chassis. I dont think you can fit 3in without cutting the front raditior support.

http://i24.tinypic.com/107u9p4.jpg
 
Last edited:
I also used 2.5. Havent got it runnin yet to say its good.

But would think if you go to big and cant push the air fast enough you may have a lag. Not even sure if superchargers have lag like turbos:confused:

I was able to fit 2.5 with keeping my a/c and no cutting to the chassis. I dont think you can fit 3in without cutting the front raditior support.

http://i24.tinypic.com/107u9p4.jpg

How big is your core?
 
Back
Top