PDA

View Full Version : MPIII case

Tony8470
12-25-2007, 01:47 AM
This is a reworked case. No plenum. I can include some uncoated rotors and new needle bearings for a small fee. $450
89XR7TD
12-25-2007, 08:32 PM
What exactly does that mean? Just curious,

Tom
Tony8470
12-25-2007, 08:40 PM
I bought it with what I was told, was a crack where one of the needle bearings goes. My machinist gave it a once over and it's ready to go. The crack that occured was from being overdriven %35. I never planned to overdrive it that far so I wasn't worried about it. It is open to offers as well.
Flex
12-27-2007, 06:43 PM
Tony,

When you say he gave it a once over, does that mean he welded the crack or just looked at it?
Tony8470
12-28-2007, 08:48 AM
We actually had a few days going over it. He didn't modify it. I went to aluminum welders to see what they would say as well. The "hairline crack" was actually a ~~~~~~ weld. My machinist said he would run it. And I will run it if no one wants it. It's very obvious that its not a crack, just a welder with little skill.
OxmanWI
12-28-2007, 02:27 PM
Do you have a picture of the crack / weld job?
Tony8470
12-29-2007, 05:07 PM
http://i7.photobucket.com/albums/y297/supercatxr7/DSC01098.jpg