PDA

View Full Version : trans tail housing removal



92sclikenew
01-21-2008, 07:45 PM
how hard is removing the housing...

i need to switch one from one tran to the other trans.. and need to know whats all needed just remove the 4-6 bolts and make sure the speedo sensor is out.. and all.. or.. is it more then that...

THE BIRDMAN
01-21-2008, 09:59 PM
You got it just remove the speedo sensor(you might be able to remove the housing without removing it)and pull the bolts out.Then just clean up you're gassket surfaces and either put a fresh tail housing gasket in or rtv replaace the old tail housing with the new and tighten the bolts back down and you'll be good to go.


Jay

92sclikenew
01-21-2008, 10:20 PM
You got it just remove the speedo sensor(you might be able to remove the housing without removing it)and pull the bolts out.Then just clean up you're gassket surfaces and either put a fresh tail housing gasket in or rtv replaace the old tail housing with the new and tighten the bolts back down and you'll be good to go.


Jay

thanks for the confirm....;)

THE BIRDMAN
01-22-2008, 01:20 AM
thanks for the confirm....;)



No problem.



Jay