The motor in my 89 XR7 spun a rod bearing about 6 months ago, and I'm finally getting around to fixing it. I have another engine that I pulled out of a 90 XR7, so I figure I'll rebuild this one and then just swap them out. Once done, this car is going to be a daily driver, so I don't want to go too crazy with it, but I would like to get some more power. Hopefully the cylinder walls will clean up with just honing, then I won't have to get new pistons and I can spend the money somewhere else. Everything else looked good in this motor, so I'll clean it all up and put new bearings and rings in it, and it should be good to go. But while I'm in here, where would my time and money be best spent to get some more power and reliability?