Search:

Me and my kids enjoy watching bass boosted car videos on YouTube. Videos last the duration if a music track. All they do is slide around most are filmed in Europe, I find it entertaining watching...

Thank you I’ll give it a shot

I agree with the heat! Another reason I ended up with the mark rug. The fibers are more uniform and plush over the curly nappy a stocker had. Before discarding, bring it to the power wash bay highest...

I was unhappy when I didn’t order it. Wrinkles and no extra insulation. Cut pile was cheap too.

Anyone remembers?

I had bought the ACC before and took it out. The opal didn’t quite match, charcoal gray or any darker gray actually accents the car better than the monochromatic look Ford was going for in the 90s my...

Any tips on how to remove replace a throwout bearing? Does it just pry off? I forget how to do this I usually just do the whole thing.

The main sewing machine sounds I was worried about went away after the oil change. But if I tackle the front cover leak this winter I will inspect that and likely replace. Lifter noise seems normal...

Maybe try stitching it. But maybe a truck tire splash guard might be large enough to trace.

I know. Just want to end the season with a running car. IÂ’ve put on a lot of miles this summer, trying to ensure the clutch is properly seated, and gone on many rallies to shows and meets and some...

Update.
Changed the oil, did 40 weight I was running 30w, I had done it at the start of the summer, car sounds back to what I am used to. Not sure if the oil was thinned out. It was a quart or so...

Before I part this cancer of a car, I’d like to remain calm and definitively check my brain and senses because I swear I am loosing it or maybe I just know the car too well. Here we go, so my car has...

At a loss with the extra relays and wiring. I found a way of energizing the lo wire with a fourth relay. And tested the system via the KO code reading sequence. I got them at the slow speed when the...

My money is on the driveshaft. I chased a vibration for nearly a decade, I have the group buy Kelly Simmons and that required to use your own yoke etc. Well the whole thing was out of balance and...

Almost had it working, both fans turned on at 6v each when Lo went hot, but when the Hi wire goes hot the monkey wrench on my car is that the LO speed shuts off. So I’m left with only one operating...

I finished installing the new Mishimoto fans, I cant share pics they are always too big! And unfortunately summer decided to pack it up and temps in Boston are mid seventies, so just like every year...

Excellent info gentlemen.

Ralph I like the parallel idea. Never knew fans can be run like that to slow them down. That would help with longevity assuming at low speeds it gets it done in mild...

Never provided an update here, I had a vid on facebook, clutch made it to 250miles and I started to lean on it a bit 1,2,3 under full power and it has held up just fine, no sign of slipping, no...

Ive had the tack bury to the wrong side, with a loss of electrical power after a WOT run. It will reset once it receive the right signal.

It depends if I am going to run a shroud on them, with one, both fans need to be on otherwise hot air will just circulate from the stalled fan, path of least resistance. Or as an alternative I run a...

The SPAL was on an external relay, not trying to reinvent the wheel, they advertise 10A during continuous use but I doubt that’s accurate with how much flow they put out, I want two fans as a safety...

So the heat got to SPAL fan as expected running 100% this will be my third spal fan that has quit and stated to draw too much amperage. So on a new quest to repair and resolve the issues, as a last...

ThatÂ’s what IÂ’m saying, little embarrassing leaving the spot with a cloud of clutch smoke, and a little guilty cause that stuff will give someone in that crowd cancer according to California.
...

Posted some pics of the damage on FB and had a conversation over there with Corey, he ran a hybrid CenterForce PP with a RAM Sintered Iron disc on both faces on his turbo SC with good results. That...

Bump for thoughts on the Centerforce DFX, seems like a new option for our cars, my 1/4 miles days are over but want the clutch to take the street abuse. Ive blown up two Center Force II disks in my...