Search:

Type: Posts; User: figulaz

Page 1 of 18 1 2 3 4

Search: Search took 0.02 seconds.

  1. Replies
    5
    Views
    551

    Looks like your knock sensor. Youíre all over...

    Looks like your knock sensor. Youíre all over the crank sensor trigger ring deal. With the 94 you gain floating piston pins with the little retainer deals in the piston instead of the heat up conn...
  2. Thread: Fuel pressure

    by figulaz
    Replies
    7
    Views
    496

    Fuel pressure should be 38-40 psi key on engine...

    Fuel pressure should be 38-40 psi key on engine off. At idle it should be 35 psi and if you blip the throttle it should jump up to 50 for a second.
  3. Received today Thanks!!

    Received today Thanks!!
  4. Thanks Tim! Ordering now

    Thanks Tim! Ordering now
  5. Do you still have one of these?

    Do you still have one of these?
  6. Replies
    2
    Views
    522

    Jack shaft bearing or bracket

    Well it finally happened. Jackshaft bearing making an awful racket. Pls contact if you have the bearing alone to ship or the whole known good passenger side accerory bracket. 3 months ago I sent...
  7. Replies
    6
    Views
    832

    Thanks!

    Received right away! packaged well and couldn't be happier. Thank you!
  8. Replies
    6
    Views
    832

    If this is for the early models Iíll take it pls...

    If this is for the early models Iíll take it pls PM me
  9. Replies
    4
    Views
    886

    Midlength headers for sale

    Selling my midlengths. They're in great shape. I used them for engine break in for about 2 months while I had a temporary operating permit and then swapped to manifolds for CA Smog. I was going...
  10. Replies
    10
    Views
    1,172

    Good point. I gotta wait until my son finishes...

    Good point. I gotta wait until my son finishes high school at least. I measured the dB with an app and I'm well within the spec at about 85 dB at 3000 rpm but it'll still set off the occasional car...
  11. Replies
    10
    Views
    1,172

    New California exhaust law for 2019

    New law just went into effect in CA for ďloud exhaustĒ. Drivers face a mandatory $1000 fine instead of a fix it ticket. This is not an emissions thing. It impacts all vehicles under 6000 lbs...
  12. Replies
    4
    Views
    621

    that's pretty odd..i've never had bolts strip. ...

    that's pretty odd..i've never had bolts strip. In junk yard situations when I don't have a puller I reinstall the center bolt about 2- 3 turns and maneuver my knee under the wheel to create a...
  13. Replies
    4
    Views
    461

    check the fusible link ground in front of the...

    check the fusible link ground in front of the battery. I've left that one loose after doing some work and had similar symptoms .. retrace your steps and check all the grounds you can see while...
  14. Solved?? Kinda?!

    For my situation I ended pulling the ignition harness and re-taping and putting new corrugated wire loom sleeves. I tested plug wires with voltmeter everything checked out. I think what may have...
  15. Replies
    7
    Views
    255

    Sounds good. Iíll try and return it. I Will not...

    Sounds good. Iíll try and return it. I Will not be denied AC this summer!!!
  16. Replies
    7
    Views
    255

    I didnít grenade. More like a leak through the...

    I didnít grenade. More like a leak through the top. Kind of like when an oil sender unit starts leaking but this seem a little more violent with oil splattered on the hood and engine compartment
  17. Replies
    7
    Views
    255

    I didnít grenade. More like a leak through the...

    I didnít grenade. More like a leak through the top. Kind of like when an oil sender unit starts leaking but this seem a little more violent with oil splattered on the hood and engine compartment
  18. Replies
    7
    Views
    255

    I'm not in front of it but this must be it ...

    I'm not in front of it but this must be it

    https://www.autozone.com/cooling-heating-and-climate-control/a-c-switch/santech-a-c-switch/175015_115711_0
  19. Replies
    7
    Views
    255

    climate control pressure switch bursts

    After the AC was figured out I decide to put the car on jackstands last weekend to swap gtp rotor pack change oil,spark plugs, pull and inspect harness etc. I walk out today and see a oil puddle. ...
  20. DTC217 solved

    So I got lazy and decided to throw a ICM this morning at the problem instead of actual diagnostic work and it drove fine for about 5 mins and the I got the 211 pip code. It kind a bucked and wanted...
  21. Thanks guys. Turned out to be a bad pressure...

    Thanks guys. Turned out to be a bad pressure switch and not enough refrigerant. Plenty cold now. 1st SC with working AC. Wooohhoooo!
  22. DTC 217 Primary ignition coil failure coil#3

    More super coupe life problems. I think I’m chasing a short. So before i started trying to get my AC going I got a drivability issue Lost of power at startup Rough idle wide band would go dead...
  23. The compressor was from an old engine pull and...

    The compressor was from an old engine pull and looked dusty and open to the environment so I poured ac flush in and cycled it through on the bench with a clutch wrench tool. New seals on top. I...
  24. AC resurrection R134. Super Coupe is fighting me

    I need help with the AC. I rinsed condenser changed hi pressure hose with filter and receiver dryer rinsed compressor and added oil. Vaccum pumped to 35 hg and held for 30 mins. I went to charge...
  25. Replies
    3
    Views
    365

    Solved

    1993 Lincoln town car blower resistor module works. Plug is the same but you need to trim alignment holes and re drill new holes. These cars are getting harder to find
Results 1 to 25 of 428
Page 1 of 18 1 2 3 4