Search:

Type: Posts; User: 91supacoop

Page 1 of 20 1 2 3 4

Search: Search took 0.05 seconds.

  1. Replies
    12
    Views
    701

    They get so yellow in the sun so I'm sure I...

    They get so yellow in the sun so I'm sure I replaced them when I got the car. IIRC they were $155 a piece at the time and they make the car look so much better it's a no brainier. Over never owned or...
  2. Replies
    12
    Views
    701

    Ya know.... Your name sounds familiar.I think I...

    Ya know.... Your name sounds familiar.I think I may have bought a bumper from you eons ago. If you are who I am thinking of, you had about 10 SCs (maybe they weren't all SCs, maybe there were other...
  3. Replies
    12
    Views
    701

    After a VERY long hiatus, I'm back

    I moved from MI to NY and didn't have the money, time or space to work on my SC. It's a CMRE stage 2 with a 1.7L AR on it with all the bolt-ons under the sun. It sat virtually untouched for 10 years...
  4. SCT chip w/ 80mm C&L MAF 36/38 (BLUE) - Never USed

    As I said in my previous posts, I used to be active on these forums and then life happened. Anyway, I still have my SC, but the way things went I ended up not using certain parts when I built my...
  5. Replies
    6
    Views
    622

    A1000 Fuel Pump - Never used

    AS I said in my previous post I used to be active on these forums and then life happened. Anyway, I still have my SC, but the way things went I ended up not using certain parts when I built my motor...
  6. Replies
    0
    Views
    276

    87mm MAF - Never used

    Hey all, I used to be active on these forums and then life happened. Anyway, I still have my SC, but the way things went I ended up not using certain parts when I built my motor forever ago. I'll...
  7. Replies
    1
    Views
    301

    nevermind, I got it! For future reference: ...

    nevermind, I got it!

    For future reference:

    LT BLU: Sensor Ground
    DK GRN: Not Used
    RED/LT GRN: +12
    PNK/BLK: Signal
  8. Replies
    1
    Views
    301

    Cam sensor wiring

    Hi everyone,
    I searched briefly on the subject, but i was unable to locate any relevant information. I'm at a loss and really don't know what else to do, so any help would be appreciated.

    I...
  9. Camshaft position sensor...what usually goes bad?

    is it the synchronizer that usually goes bad, or the plastic cap? I replaced the cap with a new one and am still getting a camshaft position sensor code. The wiring all checks out.

    When i go...
  10. you're talking nonsense.....nobody knows what...

    you're talking nonsense.....nobody knows what you're talking about
  11. ::Follow up::

    ::Follow up::

    A good ignition signal to wake up the controller is from the IRCM. I peraonally used it right out of the IRCM in the Passenger side front corner of the engine comparment to run all...
  12. ::followup::

    ::followup::



    this is the tach signal wire. if you have an aftermarket controller and would like to use a Tach output from that controller to drive the stock tach....use this wire. It is on a...
  13. Replies
    7
    Views
    405

    ::Follow up::

    ::Follow up::

    The culprit was a wire that goes to the light for the ashtray. I replaced the fuse, and the wire (under the center console going from the armrest towards the climate control unit)...
  14. Replies
    17
    Views
    1,246

    PM sent regarding 3 interior dash parts.

    PM sent regarding 3 interior dash parts.
  15. Replies
    6
    Views
    378

    the seat belt is stuck in the back position, so...

    the seat belt is stuck in the back position, so while i am safe it's a nuisance to get into and out of the car. There are no seat belt alarms or door ajar chime.

    I'll check the inertia switch,...
  16. Replies
    11
    Views
    707

    While I just pulled the dash out, and I have a...

    While I just pulled the dash out, and I have a pretty good understanding of how I would do it again in the future, the FSM pages, and your tutorial would be most appreciated.



    Yeah, I don't...
  17. Replies
    11
    Views
    707

    I despise ford engineering ::RANT::

    Whoever came up with the mounting for the dashboard top (the part that is on the drivers side over the radio and gauge cluster should be put in the same windowless room as the guy who came up with...
  18. Replies
    6
    Views
    378

    DS power seatbelt not functioning

    the Drivers side power seatbelt doesn't go forward or backwards. The passenger side does, does anyone know of some common problems for this?
  19. Replies
    12
    Views
    1,041

    looks like David made the connection:D yeah,...

    looks like David made the connection:D

    yeah, it took me a long time to get my ~~~ in gear and finally put it in the car.
  20. Replies
    12
    Views
    1,041

    Jay, if the pump isn't supplying enough pressure,...

    Jay, if the pump isn't supplying enough pressure, you can open the injectors at 100% duty cycle, and they won't flow enough.....compare it to the faucets in your house. If you have only 15 PSI of...
  21. Thread: t5 in a sc

    by 91supacoop
    Replies
    5
    Views
    686

    The torque curve of the 3.8 with the roots...

    The torque curve of the 3.8 with the roots blowers is not good for the T5. The high torque at a very low RPM will rip it to shreds...supposedly. This was the justification for using the M5R2 ( a...
  22. Replies
    12
    Views
    1,041

    I tend to agree with Kevin on this one. If I...

    I tend to agree with Kevin on this one. If I need more fuel, I would rather get a bigger pump, than a voltage booster.

    I do like the idea of running two 255LPH fuel pumps, that is definitely a...
  23. Replies
    12
    Views
    1,041

    A1000 with stock tank

    Has anyone done this? I would like to maintain the stock tank to preserve the relatively flat underside of the car while also maintaining my trunk space and spare tire location.

    I was planning...
  24. Rod, thanks for your help. Since I have wired in...

    Rod, thanks for your help. Since I have wired in the fans to my aftermarket controller, and have replaced the fuel pump circuit, am I correct to assume that I can eliminate the module?

    The wire...
  25. unknown module front passenger in front of air box, behind headlights

    hey everyone. as some of you may remember, I went with a standalone controller, and I am working on removing the PCM and associated wiring harnesses. Unfortunately I left both of my chiltons...
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4