Search:

Type: Posts; User: lfiers889

Search: Search took 0.03 seconds.

  1. Replies
    19
    Views
    1,439

    Computer OK?

    Here is what I think is going on. When I turn the key to on the computer reads 'some things' and if it don't get the right readings it does not ground the fuel pump to charge the system and it does...
  2. Replies
    19
    Views
    1,439

    Thanks

    Thanks, that fixed the buzzing when I applied dielectric grease to all the terminals. Now it is back to no fuel pump charging the lines. The inconsistency is crazy. Am trying to read codes with...
  3. Replies
    19
    Views
    1,439

    Now that's interesting-Getting weird

    Borrowed a scanner and while trying to get it to read codes turned on switch and the fuel pump charged the lines, so I hit the starter and it starts and runs fine. Apparently computer did not burn...
  4. Replies
    19
    Views
    1,439

    SC eats Computer for lunch

    Replaced computer, turned key and fuel pump charges fuel lines, hit starter and car starts and runs, problem solved......for about 5 minutes. Car coughs, sputters, and dies. Turned key off, turned...
  5. Replies
    18
    Views
    2,499

    Computer for 5 speed

    I need the PCM (computer) part # F1WF-12A650-AA. Email is lonn1950@gmail.com
  6. Pcm

    Need PCM for a 91 5 sp part # F1WF-12A65O-AA
    nOT SURE pm IS WORKINg but email is lonn1950@gmail.com
  7. Replies
    19
    Views
    1,439

    Looking for used computer

    I may be wrong here but I read if I have spark the ICRM EEC relay is working. I have spark. What I don't have is fuel pump pressure at key on, should run a few seconds. I checked the fuel pump...
  8. Replies
    19
    Views
    1,439

    Bad Computer?

    Since fuel pump works when grounding self test terminal for pump and since tried to read codes but check engine light stays on indicating hard fault (open or short circuit) I believe I need a...
  9. Replies
    19
    Views
    1,439

    Bad computer>

    I tried to run the codes but check engine light stays on when I hook up. Book says that indicates short or open circuit. Fuel pump runs when grounding self test connector for pump indicating...
  10. Replies
    1
    Views
    194

    Computer for 91 SC

    Need stock computer, the one behind the passenger's kick panel, price including shipping.
    lonn1950@gmail.com
  11. Replies
    19
    Views
    1,439

    The latest...

    Checked the timing just by cranking engine with timing light and it is at 10 degrees per spec. So conclude harmonic balancer is installed correctly. Monig on: Fuel pump relay in trunk has 4 wires;...
  12. Replies
    19
    Views
    1,439

    Answers to questions

    The fuel line pressure is measured at the schraeder valve on the rail. The ignition switch is original. The balancer is torqued to 120 ft lbs and in line with the other pulleys. The battery is +12...
  13. Replies
    19
    Views
    1,439

    Harmonic Balancer

    The harmonic balancer is a used one with the pulley balanced to it. Same part number as original and inspected before installing, appeared to be exactly same.
  14. Replies
    19
    Views
    1,439

    No power to fuel pump relay, why?

    Have 91 SC has been running fine when some bolts holding pulley to harmonic balancer broke and others stripped out threads. Replaced Harmonic balancer and pulley, turns over but won't start. I...
  15. Replies
    18
    Views
    2,499

    Balancer?

    I need a harmonic balancer for a 91 SC. How much shipped to Lincoln, Nebraska, 68507?
    402-817-9172 for text
    Lonnie
  16. Harmonic Balancer

    Have 91 SC, needs a balancer, have you got one and how much shipped to Lincoln, Nebraska
  17. Replies
    4
    Views
    462

    Heater fan on high constantly

    I have a 91 SC with the auto temp control and it has just started running the fan on high constantly even in the off position. Any ideas?
  18. Replies
    15
    Views
    1,200

    I have found you can't trust cell phones. I was...

    I have found you can't trust cell phones. I was there so that's just how it goes some days. Tapped the collar tight and hope that does it. Have some issues now with some add on security system...
  19. Replies
    15
    Views
    1,200

    I plan on being there. Thanks again.

    I plan on being there. Thanks again.
  20. Replies
    15
    Views
    1,200

    When?

    What day and time? I am off Friday thru Monday. My cell is 402-304-3365 in case you have any last minute change of plans. I will be wearing a camo field jacket. I should have it running this...
  21. Replies
    15
    Views
    1,200

    Location

    I am in Lincoln, Nebraska. If someone has one they will loan me for a short time I would appreciate it. Willing to place a deposit on it. email is lonn1950@gmail.com
  22. Replies
    15
    Views
    1,200

    Super charger outlet collar wrench?

    I see the outlet collar is supposed to be tightened to 148 ft lbs and requires a special wrench. How does one get around the special wrench problem and still get it tight enough? Anyone try a oil...
  23. Thread: IC gaskets

    by lfiers889
    Replies
    1
    Views
    337

    IC gaskets

    I am told there is such a thing as a reusable gasket for the IC tubes. Anybody know where to get them? If these are not available what is the second best way to seal them. The tape sounds like a...
  24. Replies
    5
    Views
    524

    Thanks

    Thanks for the info. Hope to get this done before the New Year since I don't go back to work till Jan 2. Now out to the garage!
  25. Replies
    5
    Views
    524

    Engine swap 94 to 91 question

    I am putting a 94 SC engine into a 91 SC. I am told the timing cover and crank sensor and crank dampener need to be replaced with the original 91 style. Anything else I need to know?
Results 1 to 25 of 25