Search:

Type: Posts; User: potshotscott

Page 1 of 20 1 2 3 4

Search: Search took 0.03 seconds.

  1. Replies
    3
    Views
    249

    this is lol

    this is lol
  2. Replies
    37
    Views
    2,370

    There is a 94 LX in the pick and pull near me. ...

    There is a 94 LX in the pick and pull near me. Its a long shot since I'm on vacation until Aug 1 but if you still need one then shoot me a PM and I'll go take a look.
  3. Replies
    17
    Views
    547

    Any chance you can share part numbers for LED's...

    Any chance you can share part numbers for LED's you've installed? The flasher info is great - interested in the bulb choices.
  4. Can one of you tell me what I should read on Pin...

    Can one of you tell me what I should read on Pin 18 at the IRCM connector? It looks like it ought to be some sort of ground since pin 13 has Voltage applied from the EEC-IV power relay. I have to...
  5. Welp - my IRCM is not working correctly in terms...

    Welp - my IRCM is not working correctly in terms of the fuel pump circuit. I have 12V going in but I don't have 12V coming out to head to the fuel pump shutoff switch in the trunk. The car has...
  6. Thread update: The ECU is the correct one. I...

    Thread update: The ECU is the correct one. I finally got a GOOD ECT sensor and burped the car after I got it started. Idle calmed down and now the temp gauge sits in the middle while my ECT sits...
  7. Outstanding info once again. The main problem is...

    Outstanding info once again. The main problem is I'm still getting the intermittent start. I plucked a good quality CPS connector and plan to replace the connector in my car along with putting the...
  8. Update - now with more frustration! ;)

    So here's a good one. I'm pulling KOEO codes and I've seen the following over the weekend.

    10 #1 cylinder balance?
    118 ECT
    121 TPS
    113 IAT
    335 EGR

    About to throw down on a new PCM as I'm...
  9. Huge thank you to the forum owner and all who help

    So I just have to say - thank you - for all the information that is stored here. I also appreciate people like KMT and Sam Jones who are consistently polite and very knowledgeable. I read the...
  10. Thanks for the suggestion. I will take a look. ...

    Thanks for the suggestion. I will take a look. I'm pretty certain there are some mid 90's Mustang 3.8s in the u-pull near me. I'm planning a run to snag a wire harness, connector and sensor off a...
  11. Crank Position Sensor connector question

    Hey all, quick question here. I have a 94 SC that has an intermittent no start problem. I pulled my CPS this week and swapped it out for another I had. The resistance on both sensors were the...
  12. Replies
    2
    Views
    244

    Similar issue - please help!

    Edit for content as my problem has shifted. Here's what I now know:

    In 1994 SC measure 12V at pin 11 on the IRCM/CCRM module near the air cleaner (probe the back side of the module harness while...
  13. Replies
    5
    Views
    299

    Thread update. The Gates 38023 pulley (found at...

    Thread update. The Gates 38023 pulley (found at O'Reilly's) is doing the deed for me. Ordered two of them and ended up finding a solution at "gates dot com". They're search engine (by attribute)...
  14. Any interest in a larger scan of this? I could...

    Any interest in a larger scan of this? I could probably weed out the SC related stuff to make a more complete PDF.
  15. Replies
    5
    Views
    299

    Thanks Tim - the main reason I asked the question...

    Thanks Tim - the main reason I asked the question is I received my order from Rockauto that was based solely on year and engine in the car (not sizes) and I received the wrong parts. 2 90mm pulleys...
  16. Replies
    5
    Views
    299

    Idler pulleys question

    Well the old girl is 25 years old and needs new idler pulleys. They're shot and I'd like new ones. Here's the thing. I've read most of the threads in the forums and seem to believe that all three...
  17. Sticky: The speculation around 94/95 being identical in...

    The speculation around 94/95 being identical in nearly all regards makes total sense if they were known to be "on their way out" especially given the 94/95 LX was using OBDII. Would have been too...
  18. Saw your car on Craig's. Drooled a little. Good...

    Saw your car on Craig's. Drooled a little. Good luck with the sale!
  19. Replies
    5
    Views
    363

    I must say those headlights on the SC are REALLY...

    I must say those headlights on the SC are REALLY shiny. I love the 1994-1995 style and interior especially but the 89-93 headlights always look SHARP.
  20. Replies
    5
    Views
    363

    Your setup is respectable. Not sure about that...

    Your setup is respectable. Not sure about that GM product to the right though...
  21. Replies
    3
    Views
    318

    It's been a while since I've seen the stock sub...

    It's been a while since I've seen the stock sub as I pulled it a while ago. If you suspect the speaker is "blown" all you need to do is take a C cell battery and touch the positive end to one...
  22. Yes - removed the assembly and cleaned off car. ...

    Yes - removed the assembly and cleaned off car. Had reseated the connector once before with no change. Could see visible build-up.

    I believe I've found the other source of my headaches. I've...
  23. Making huge progress on this. Pulled codes and...

    Making huge progress on this. Pulled codes and am working on that but in the mean time cleaned the MAF very well and the car runs as it should now.
  24. 1994 EEC-IV Engine Supplement - Car for Super Coupe

    I'm digging into several issues that my SC has and remembered I had the HUGE EEC-IV supplemental documentation. I was skimming it and found 4 pages that I think are particularly helpful - especially...
  25. Replies
    3
    Views
    426

    Thanks Tim!

    Thanks Tim!
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4