Search:

I used a vacuum generator, I was able to retract the diafragma, but after 2-3 sec, it doesn't keep it, it returns to its original state.

I am not sure about the pedal, if the switch is correct or...

Today I checked the Servo. I removed the linkage at the throttle and checked the servo.
71372

The servo looks fine.
I checked with an ohmmeter and the reading are correct (for the parameters, I...

Last week, I retook the activities and thanks to all the inputs. I checked the brake pedal and even when I was not depressing the pedal, it was not depressing the switch; I am guessing the valve was...

Thanks Dave, I took my car to a shop, to take care of multiple things such as: brakes, AC, tensioners and idle issue. The gentleman has been working with Fords for many years and he fixed the car by...

I have a good CCU that I bought when I was troubleshooting my AC problem. It is in good condition, I tested it in my car.
$50

71355
71357
71356
71358

Hi guys, I primarily looking for the clip. Hopefully if you don't have the full system, you have just the clip. thanks.

71354

Hi I am looking for a Vehicle Maintenance Monitor for a Thunderbird 89-93. Any conditions, I am mainly looking for the side clips.

I would like to recommend Mustang Service Center, 3613 Live Oak St, Dallas, TX 75204, (214) 824-6716. They did an amazing job on my car. Craig has been working on this car since the 90's, while he...

Thanks rbrown, I will the review the 88 MC. The following thread describes the cubic inches of fluid for 1 inch of brake pedal travel.


On a 1989-1992 SC, to move .7cubic inches of brake fluid,...

Hi, I took me 2 days but I have gone to this thread. Unfortunately my ABS broke last week and I am not sure if I should sent it to supercoupe for remanufacture or replace it.

In terms of the MC I...

Hi KTM about your questions



-- Yes, the tensioners have their ears.
70922 70923

I checked the belts and I think they are in parameters (0.1 - 0.2 inches bigger).

PART NUMBER | METRIC Part NO. | NO RIBS | EFFECTIVE LENGTH | OUTSIDE LENGTH...

Thanks Sam, let me check the parts were installed in the right place and using the correct belts. If the parts look to be in the correct place, I will proceed to buy the correct tensioners using you...

Thanks, I will also check the part numbers for the belts.

thanks KTM,

This is valuable information. I bought the car and I got the impression that the previous owner was trying to fix it and gave up; and put the parts together but missed connecting many...

Hi Ricardo, I just bought the car few months ago and the previous owner bought the belts. I checked the belts and they look brand new. The indicators on two of three was in the replacement section.
...

Hi, I am trying to buy the Belt Tensioner Assembly but I cannot figure out the part numbers. Autozone couldn't tell me the exact part and I will appreciate the help.

I had a Squeaky and after...

Thanks tberger06, let me tell you what I did today.

Today, I checked the connector that I think it is C109 (I am not sure if it is C109 or other). This connector is located in the front of the...

Hi KTM, thanks for your inputs. About your questions:

Have you removed the horn pad on the steering wheel and verified those connections are healthy?
Yes, I removed them and checked them. Those...

Thanks for the guys who told me that I was looking in the wrong place. The connector C207 is color GRAY and located in the brake pedal. I checked with a multi meter the resistance. Comparing the...

Thanks Blackv8, I will finish fixing the suspension... and now I feel more confident buying those tires. Once again Thanks!

Hi guys I am in process of buying new tires. I am looking for a tire without interference. I review the below link:
http://www.sccoa.com/forums/showthread.php?9646-Widest-16-quot-tire-on-stock-rim...

Hi guys, I finally fixed some issues in the speedometer and the ABS sensors. I tried the Cruise Control (CC) but did not work. I reviewed the Manual and tried to start testing connector C207. I have...

I just upgraded my brakes and I replaced the whole upper control arm. I don't think you can just find the ball joint.

70825

Hi guys, I will appreciate your help and tips on this problem. I started reviewing the issue with the AC, the first thing I was getting "E3" code that displays on the electronic climate control - I...