Search:

Type: Posts; User: Tim Groth

Page 1 of 20 1 2 3 4

Search: Search took 0.05 seconds.

  1. Replies
    6
    Views
    95

    I did RTV on the key way. -Tim

    I did RTV on the key way.

    -Tim
  2. Replies
    6
    Views
    95

    All of my BHJ installs slide on fine without the...

    All of my BHJ installs slide on fine without the honing etc. I have one installed with the stock pulley. 1 with a 0 balanced MP setup. No issues with either.

    I did rtv lightly, also used the...
  3. Replies
    3
    Views
    304

    Picked this SC up over the weekend. Sold. ...

    Picked this SC up over the weekend.

    Sold.

    -Tim
  4. Replies
    13
    Views
    237

    The hose you're having issues with is the coolant...

    The hose you're having issues with is the coolant line they ran thru the throttle body housing in 89 and early 90 models. It connects into the heater hose on the the drivers side. I personally...
  5. I purchased the MEVOTECH for $12. Nothing fancy...

    I purchased the MEVOTECH for $12. Nothing fancy here, car they're going on was otherwise destined for scrap so not going high end.

    Several closeouts on RA. Perfect timing for my particular...
  6. I just purchased some uppers off rockauto for...

    I just purchased some uppers off rockauto for what felt like pennies on the dollar. Might wanna check them out.

    -Tim
  7. Replies
    4
    Views
    151

    I'll buy both Pro Products Throttle Bodies. ...

    I'll buy both Pro Products Throttle Bodies.

    Send me a total Shipped to 24019.

    Thanks!

    -Tim
  8. I do not have one. Appears it didnt make the...

    I do not have one. Appears it didnt make the move.

    -Tim
  9. Replies
    3
    Views
    304

    Sent ya a text Joe - I'm a buyer. -Tim

    Sent ya a text Joe - I'm a buyer.

    -Tim
  10. Sticky: For what it's worth. I finally was able to cancel...

    For what it's worth. I finally was able to cancel yesterday. The hours being cut back at the hotel made it tricky for me to get anyone at the actual property and not a reservations line.

    Lady...
  11. Replies
    3
    Views
    178

    Use a set like this...can be found at any parts...

    Use a set like this...can be found at any parts store or harbor freight.
    ...
  12. Replies
    4
    Views
    223

    The sealer around that oval vent drys up and...

    The sealer around that oval vent drys up and cracks. Usually new glue resolves the issue. There was a TSB from Ford on this issues moons ago...might find via google search.

    -Tim
  13. Replies
    4
    Views
    223

    Rather common. Issue steams from the outside air...

    Rather common. Issue steams from the outside air inlet on the passenger side...it's underneath the wiper cowl. This has happened on all my Thunderbirds/Cougars 89-97

    -Tim
  14. A used BHJ would be fine they're made of steel...

    A used BHJ would be fine they're made of steel and not aluminum so you do not have to worry about stretching. Personally I'd trust a used BHJ more so than a rebuilt factory unit. All of my SCs have...
  15. So based on the Ford part number listed on Rock...

    So based on the Ford part number listed on Rock Auto - that balancer is for the NA 3.8 engine and not the SC engine
    ...
  16. Thread: 89xr7

    by Tim Groth
    Replies
    3
    Views
    255

    The car is worth more in parts than the purchase...

    The car is worth more in parts than the purchase price of $650.

    Based solely on that it's a good purchase in my eyes.

    -Tim
  17. Sticky: Lovely 😂 -Tim

    Lovely 😂

    -Tim
  18. Replies
    3
    Views
    225

    I usually drink enough at Carlisle to avoid the...

    I usually drink enough at Carlisle to avoid the fears of viruses...maybe the MA-ADT can have a rebirth. Coronie killers could be the name of our new high test mixer.

    I'm still planning on going...
  19. Replies
    5
    Views
    401

    Permatex® Water Pump & Thermostat RTV Silicone...

    Permatex® Water Pump & Thermostat RTV Silicone Gasket Maker -
    Category: Gasket Makers
    A noncorrosive, sensor-safe RTV silicone gasket material formulated specifically for water pumps and thermostat...
  20. Replies
    5
    Views
    401

    I'd leave the timing chain and tensioner alone, I...

    I'd leave the timing chain and tensioner alone, I doubt iit's bad. Some of the replacements aren't as good as OE anyways. On the oil pump I'd leave it be HOWEVER I would replace the rubber gasket...
  21. Not sure on a Gasket, have always used black RTV....

    Not sure on a Gasket, have always used black RTV.

    How I did mine. Either brace cross the shock towers with steel, 4x4 or an engine hoist to hold the engine up.

    Jack up front of the car. ...
  22. I've successfully replaced an oil pan gasket...

    I've successfully replaced an oil pan gasket without pulling the motor, but I wouldn't say it was any easier to do.

    I dropped the K member and had a support beam across the shock towers holding...
  23. Sounds similar to what I experienced on my 1989...

    Sounds similar to what I experienced on my 1989 Manual SC when the cam sensor failed.

    Easy enough to trouble shoot by unplugging it and trying to start the car without it hooked up. Usually takes...
  24. Replies
    1
    Views
    297

    That's the stock rear coil spring part number btw...

    That's the stock rear coil spring part number btw per rockauto.

    -Tim
  25. I notice you have the main belt off, hope you...

    I notice you have the main belt off, hope you loosened the 4 bolts on the Jack shaft pulley first.

    You can take the majority of the top end off in large sections also to make what seems like a...
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4