Search:

Type: Posts; User: KMT

Page 1 of 20 1 2 3 4

Search: Search took 0.03 seconds.

  1. Replies
    5
    Views
    115

    That confirms the fuse/power is ok. If it was a...

    That confirms the fuse/power is ok. If it was a problem w/the inputs, the VMM should still at least light up.

    I'd want to pull it and be sure it's rear connector is still socketed. If it is, I'd...
  2. Replies
    5
    Views
    115

    Is that the only thing not working? Does the...

    Is that the only thing not working?

    Does the A/C clutch engage?
  3. Replies
    2
    Views
    120

    Yes, even with the soft materials on the...

    Yes, even with the soft materials on the underside of the back seat cushion, I don't feel good about wiring there.

    I've only lifted the carpet enough to look right next to the sill/door rubber,...
  4. Replies
    2
    Views
    120

    Aftermarket Stereo Wiring - Tunnel or Sills

    For those of you that have run wires between the dash and trunk for your sub-woofer and amp on your SC, did you end up running them from the center of the dash to the outside, then along the sills,...
  5. Replies
    19
    Views
    761

    Not sure if I correctly ID'd the connector in the...

    Not sure if I correctly ID'd the connector in the photo now that I look closer, sorry, I need the ABS pump motor connector, female/harness side, the one with the clips/keeper tangs...if Rich can't...
  6. Replies
    19
    Views
    761

    PM sent, thanks

    PM sent, thanks
  7. Replies
    19
    Views
    761

    Jacob: If you're not using the 4-pin connector...

    Jacob:

    If you're not using the 4-pin connector sticking out above and to the right of the booster, the one w/the red gasket inside it, I can use it on my Anny. Cut that guy loose and let's make a...
  8. About removing the bleed bolt now...at this...

    About removing the bleed bolt now...at this point, I'd leave it, and the cap, alone and instead concentrate on the level in the expansion tank.

    Minor air after filling is passed out via the...
  9. Thread: LED lights

    by KMT
    Replies
    17
    Views
    514

    I haven't made the leap to LED head/tail, cluster...

    I haven't made the leap to LED head/tail, cluster yet, but I've tried to do the rest. I did the backup lights first, back in 2011, and they were the most expensive but a big improvement. There...
  10. Good info, thanks. Note the Ford dealer wants...

    Good info, thanks. Note the Ford dealer wants USD$1.67 each, $3.34 both.
  11. Discussion here on using MLS without finishing...

    Discussion here on using MLS without finishing the block surface: http://www.sccoa.com/forums/showthread.php?66608-M-L-S-head-gaskets&highlight=mls+without+finishing+the+block

    About using...
  12. Yes, pass. side rear is a very common location....

    Yes, pass. side rear is a very common location. Same thing I found on my '90.

    No coolant in the oil, but bubbles/gases in the expansion tank, and plugged cats.
  13. You've identified at least one fail, no doubt....

    You've identified at least one fail, no doubt. I've got a used gasket that looks just like it ;)

    What cylinder is that? Passenger side rear?
  14. TTY bolts are 'springy', meaning they can act...

    TTY bolts are 'springy', meaning they can act funny when you try to remove them, especially by hand.

    Save yourself the struggle, use an impact to pull them, and don't worry about what someone...
  15. Replies
    10
    Views
    482

    A '10' is a pause/separator, not a code. If...

    A '10' is a pause/separator, not a code.

    If the engine was completely warmed up and goose tested at the appropriate time etc., those are confusing codes to all see at the same time... I'd wonder...
  16. Replies
    10
    Views
    482

    The click is when the external plastic keeper...

    The click is when the external plastic keeper grabs. If you want to worry about something, worry about if the metal pins & tangs are making reliable contact inside the connector. Even if the keeper...
  17. I've only used Fel-Pro and had good luck. I also...

    I've only used Fel-Pro and had good luck. I also had my heads refinished to RA20 (a smoothness factor).

    Others can chime in on MLS gaskets, but they should be paired with ARP studs vs. bolts, and...
  18. Replies
    13
    Views
    426

    Grounds... Tons, from the center bolt at the...

    Grounds...

    Tons, from the center bolt at the ECU, to the short cable from the pass. side motor mount over to the body, to the single wire that grounds the injectors that hides on the rear of the...
  19. Replies
    13
    Views
    426

    Ah, yes, of course, thanks. BTW, any time you...

    Ah, yes, of course, thanks. BTW, any time you pull a connector, be sure to check it for corrosion, loose pins, missing keepers, etc. Same with grounds...take them off, clean if possible, replace if...
  20. Replies
    13
    Views
    426

    The linked thread above includes this link for a...

    The linked thread above includes this link for a no start check...did you do any of that yet?

    Not the alarm light, it's about if the upshift light is on while cranking to start - if so, that...
  21. If the oil on the dipstick is milky, sure, don't...

    If the oil on the dipstick is milky, sure, don't bother. But when it's not conclusive, testing for gases in the coolant helps being able to decide without simply jacking up the radiator cap and...
  22. Replies
    13
    Views
    426

    AutoZone used to test them here in the PNW, with...

    AutoZone used to test them here in the PNW, with vague success...about 4 years ago they went full stop and declined to test them at all. This was about the same time the price fell dramatically, and...
  23. Replies
    13
    Views
    426

    He said he already has a box of them...the...

    He said he already has a box of them...the question was how to test those.
  24. Thread: Black XR7

    by KMT
    Replies
    9
    Views
    401

    Mike: Got it, thanks. I take it you meant...

    Mike:



    Got it, thanks. I take it you meant the cam sensor stalk when you said 'electronic distributor'.

    See this thread on how to set it up:...
  25. Thread: Black XR7

    by KMT
    Replies
    9
    Views
    401

    Sorry, I assumed when you said XR7 you meant the...

    Sorry, I assumed when you said XR7 you meant the Mercury Cougar version of the Ford Thunderbird Super Coupe, supercharged V-6. Those are the models I had in mind when discussing troubleshooting, but...
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4