Search:

Type: Posts; User: yayo_ayala

Page 1 of 5 1 2 3 4

Search: Search took 0.01 seconds.

  1. Replies
    10
    Views
    690

    Servo

    I used a vacuum generator, I was able to retract the diafragma, but after 2-3 sec, it doesn't keep it, it returns to its original state.

    I am not sure about the pedal, if the switch is correct or...
  2. Replies
    10
    Views
    690

    Servo

    Today I checked the Servo. I removed the linkage at the throttle and checked the servo.
    71372

    The servo looks fine.
    I checked with an ohmmeter and the reading are correct (for the parameters, I...
  3. Replies
    10
    Views
    690

    Break Pedal

    Last week, I retook the activities and thanks to all the inputs. I checked the brake pedal and even when I was not depressing the pedal, it was not depressing the switch; I am guessing the valve was...
  4. Thanks Dave

    Thanks Dave, I took my car to a shop, to take care of multiple things such as: brakes, AC, tensioners and idle issue. The gentleman has been working with Fords for many years and he fixed the car by...
  5. Climate Control Unit Thunderbird Cougar 90-93

    I have a good CCU that I bought when I was troubleshooting my AC problem. It is in good condition, I tested it in my car.
    $50

    71355
    71357
    71356
    71358
  6. Clip

    Hi guys, I primarily looking for the clip. Hopefully if you don't have the full system, you have just the clip. thanks.

    71354
  7. WTB Vehicle Maintenance Monitor (VMM) 89-93

    Hi I am looking for a Vehicle Maintenance Monitor for a Thunderbird 89-93. Any conditions, I am mainly looking for the side clips.
  8. Replies
    1
    Views
    395

    Dallas

    I would like to recommend Mustang Service Center, 3613 Live Oak St, Dallas, TX 75204, (214) 824-6716. They did an amazing job on my car. Craig has been working on this car since the 90's, while he...
  9. Replies
    555
    Views
    120,832

    Thanks rbrown, I will the review the 88 MC. The...

    Thanks rbrown, I will the review the 88 MC. The following thread describes the cubic inches of fluid for 1 inch of brake pedal travel.


    On a 1989-1992 SC, to move .7cubic inches of brake fluid,...
  10. Replies
    555
    Views
    120,832

    Proportioning valve

    Hi, I took me 2 days but I have gone to this thread. Unfortunately my ABS broke last week and I am not sure if I should sent it to supercoupe for remanufacture or replace it.

    In terms of the MC I...
  11. Hi KTM about your questions -- Yes, the...

    Hi KTM about your questions



    -- Yes, the tensioners have their ears.
    70922 70923
  12. and if the belts are different, how to check the pulley.

    I checked the belts and I think they are in parameters (0.1 - 0.2 inches bigger).

    PART NUMBER | METRIC Part NO. | NO RIBS | EFFECTIVE LENGTH | OUTSIDE LENGTH...
  13. Thanks Sam

    Thanks Sam, let me check the parts were installed in the right place and using the correct belts. If the parts look to be in the correct place, I will proceed to buy the correct tensioners using you...
  14. Thanks

    Thanks, I will also check the part numbers for the belts.
  15. Thanks

    thanks KTM,

    This is valuable information. I bought the car and I got the impression that the previous owner was trying to fix it and gave up; and put the parts together but missed connecting many...
  16. Belt

    Hi Ricardo, I just bought the car few months ago and the previous owner bought the belts. I checked the belts and they look brand new. The indicators on two of three was in the replacement section.
    ...
  17. Question identifying the Belt Tensioner Assembly

    Hi, I am trying to buy the Belt Tensioner Assembly but I cannot figure out the part numbers. Autozone couldn't tell me the exact part and I will appreciate the help.

    I had a Squeaky and after...
  18. Replies
    10
    Views
    690

    thanks tberger06

    Thanks tberger06, let me tell you what I did today.

    Today, I checked the connector that I think it is C109 (I am not sure if it is C109 or other). This connector is located in the front of the...
  19. Replies
    10
    Views
    690

    Thanks KTM

    Hi KTM, thanks for your inputs. About your questions:

    Have you removed the horn pad on the steering wheel and verified those connections are healthy?
    Yes, I removed them and checked them. Those...
  20. Replies
    10
    Views
    690

    looking in the wrong place

    Thanks for the guys who told me that I was looking in the wrong place. The connector C207 is color GRAY and located in the brake pedal. I checked with a multi meter the resistance. Comparing the...
  21. thanks

    Thanks Blackv8, I will finish fixing the suspension... and now I feel more confident buying those tires. Once again Thanks!
  22. Question about BFGoodrich g-Force 255/50/16

    Hi guys I am in process of buying new tires. I am looking for a tire without interference. I review the below link:
    http://www.sccoa.com/forums/showthread.php?9646-Widest-16-quot-tire-on-stock-rim...
  23. Replies
    10
    Views
    690

    Cruise Control

    Hi guys, I finally fixed some issues in the speedometer and the ABS sensors. I tried the Cruise Control (CC) but did not work. I reviewed the Manual and tried to start testing connector C207. I have...
  24. I just upgraded my brakes and I replaced the...

    I just upgraded my brakes and I replaced the whole upper control arm. I don't think you can just find the ball joint.

    70825
  25. Replies
    0
    Views
    250

    Need help with the AC

    Hi guys, I will appreciate your help and tips on this problem. I started reviewing the issue with the AC, the first thing I was getting "E3" code that displays on the electronic climate control - I...
Results 1 to 25 of 120
Page 1 of 5 1 2 3 4