Search:

Type: Posts; User: KMT

Page 1 of 20 1 2 3 4

Search: Search took 0.05 seconds.

  1. Just the motor? Is there a part # on yours? PM me...

    Just the motor? Is there a part # on yours? PM me that info and I'll check my spares.

    Ken
  2. Thread: 2020 Calendar

    by KMT
    Replies
    3
    Views
    25

    Maybe time to do something different this year. I...

    Maybe time to do something different this year. I was just at the print shop and they can make custom flags, with your image of choice, etc. for $22
  3. Thread: Hi from Spain

    by KMT
    Replies
    4
    Views
    27

    Means my thought is that you should pay special...

    Means my thought is that you should pay special attention to the motor mount on that side, but both sides might need to be replaced.
  4. Thread: Hi from Spain

    by KMT
    Replies
    4
    Views
    27

    See The Ford Thunderbird Super Coupe Buyer's...

    See The Ford Thunderbird Super Coupe Buyer's Guide

    English only, sorry.

    From the photos, it seems like a nice car. Be sure to check the motor mounts, tho, especially driver's side...looks like...
  5. Replies
    7
    Views
    128

    'running ragged' could mean any combination of...

    'running ragged' could mean any combination of things. Do your best, if you haven't already, to recover the entire shop towel to see if you can account for most/all of it. No telling what path the...
  6. Replies
    17
    Views
    254

    Feel your pain. I had a fresh one that sunk a pin...

    Feel your pain. I had a fresh one that sunk a pin when the connector was in place. It would barely make contact...sometimes - it was new so i kept looking elsewhere. These days, if there is any...
  7. Replies
    17
    Views
    254

    Strictly via the PCM as i understand it. I don't...

    Strictly via the PCM as i understand it. I don't recall any direct connection between the ECT and IRCM, otherwise.

    AFAIK, the PCM sends out the ref. voltage which the ECT uses to send a signal...
  8. Replies
    17
    Views
    254

    Ref. voltage is 4.00v ~ 5.00v - use caution when...

    Ref. voltage is 4.00v ~ 5.00v - use caution when testing.

    I eventually found my issue by checking at the ECT...was low there, and I was ready to break out my backup PCM, then I checked at the...
  9. Replies
    17
    Views
    254

    If the EVTM doesn't give enough hints, did you...

    If the EVTM doesn't give enough hints, did you see my recent thread about the fun I had my car's cooling system? Ref. voltage was off due to corrosion in a connector, but in my case there were no...
  10. Replies
    17
    Views
    254

    111? I thought that was system pass/ok? Remind me...

    111? I thought that was system pass/ok? Remind me what the issue was last time, pls./thanks.

    http://www.njtacc.com/tech/eec_codes.html
  11. Thread: Tp sensor

    by KMT
    Replies
    4
    Views
    99

    Interesting, thanks for the follow up. Ken

    Interesting, thanks for the follow up.

    Ken
  12. Replies
    1
    Views
    60

    I just sent you an email. Ken

    I just sent you an email.

    Ken
  13. Replies
    17
    Views
    254

    Nice work, Scott, thanks for the followup and...

    Nice work, Scott, thanks for the followup and g'luck w/it.

    Ken
  14. Replies
    17
    Views
    254

    Done right, I'm sure it will. Heck, I knew an...

    Done right, I'm sure it will.

    Heck, I knew an old salt that hated gaskets, adhesives -and- fasteners...he'd just weld things shut and dare them to leak ;)

    Thankfully, gaskets and adhesives...
  15. Replies
    4
    Views
    61

    The temp sender is on the thermostat housing. The...

    The temp sender is on the thermostat housing. The single wire connector is push-on. Check to confirm the threaded post and connector are not corroded, and that the connector fits snugly when pressed...
  16. Replies
    4
    Views
    61

    About the ABS, see:...

    About the ABS, see: http://www.sccoa.com/faq/Floyd%20ABS%20Article.pdf - might be a relay, might need an accumulator.

    About the rough idle...could be one or more of several issues, from bad...
  17. Replies
    6
    Views
    100

    I had an issue w/my '90 (100k miles) back in 2013...

    I had an issue w/my '90 (100k miles) back in 2013 that ended up being the connector/wiring at the latch over the door. Decided to just swap the whole track/motor assembly out for one w/less wear. You...
  18. Replies
    6
    Views
    100

    When was the last time it worked? When was the...

    When was the last time it worked? When was the last time the track was lubed? That was my issue last time the driver side acted up.

    Does opening the driver door trigger the courtesy lights? Does...
  19. Did you paint any engine components before...

    Did you paint any engine components before re-installing?

    Did you confirm the main grounds were reconnected at the pass. side motor mount-to-body, and lower front of the block on the drivers side?...
  20. Replies
    7
    Views
    128

    67 is a 'Continuous' code; Clutch Switch circuit...

    67 is a 'Continuous' code; Clutch Switch circuit failed (3.8L SC only) - See: http://www.njtacc.com/tech/eec_codes.html for SC specific code listing.

    Ignoring 29, for now, (10 is a null/place...
  21. Thread: Tp sensor

    by KMT
    Replies
    4
    Views
    99

    Know how to check the ref. & signal volts at the...

    Know how to check the ref. & signal volts at the sensor?

    Identify the power, ground and signal wires on the TPS. Do you have an EVTM?

    BK/W - ground/neg.
    O/W - signal
    DG/LG - ref.

    All...
  22. Replies
    6
    Views
    125

    Using earlier SC as example, a traditional...

    Using earlier SC as example, a traditional solenoid sits up top, on the inside of the driver side fender, behind the battery, next to the PCB (engine bay fuse box). Can't miss it. Center right in...
  23. Replies
    6
    Views
    125

    Solenoid is built into the starter on the...

    Solenoid is built into the starter on the 94/95's, no external solenoid.

    May want to check the multi-wire ignition switch (not the key cylinder) down on the right side of the column, inside the...
  24. Replies
    5
    Views
    84

    I'd be surprised if you could find new thru...

    I'd be surprised if you could find new thru normal parts houses, that's why i suggested a want ad. I see this on eBay:...
  25. Replies
    5
    Views
    84

    This is a photo of the fan used on an early SC:...

    This is a photo of the fan used on an early SC:
    https://i.ebayimg.com/images/g/bqoAAOSwfP1dOKZN/s-l1600.jpg

    Someone else would need to confirm it is the same on late model. You can see it's all...
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4