I'm getting 124 and 126 codes. The book that comes with my reader says that A)TPS voltage too high. B) MAP or BARO to high or too low.
I don't have a Shop Manual any more but my wiring diagrams show a Barometric Pressure sensor but no MAP. Is this the item that hangs on the firewall with the wiring harness plug going to it and no vacuum hoses? Sounds like I need a new one. Do you know what voltage I should read from my center wire to ground on my TPS?
George Clarke aka the SonySC@hotmail.com
I don't have a Shop Manual any more but my wiring diagrams show a Barometric Pressure sensor but no MAP. Is this the item that hangs on the firewall with the wiring harness plug going to it and no vacuum hoses? Sounds like I need a new one. Do you know what voltage I should read from my center wire to ground on my TPS?
George Clarke aka the SonySC@hotmail.com