thanks to Dan

Thanks to Paul.

I need parts .. :eek:


Heres a breif list .. for a 94/95 SC .. donations welcome :)

Heads
Rockers
Pushrods
Lifters
Supercharger + plenum
Throttle body
IC
Upper and Lower IC pipes + bracket for lower IC
Stock Radiator + Hoses
Accessory Brackets ( both sides )
Tensioners, Belts
Alternator
Harmonic Balancer
Fuel Injectors 36#
Fuel rails
Stock intake manifold
Stock inlet plenum
Crankshaft Sensor
Front Bumper Support metal + plastic
Engine to Trans Gasket
Flywheel
Pressure plate + Clutch
Coolant pipe under engine - Water pump to Oil Cooler
Exhaust Manifolds
Exhaust with Cats
Corner Marker lights ( 96/97 )
Speedometer (145 Mph )
Rear Differential (2.73 w/ TL )
EGR + Tubes
AC Pusher fan
Windshield washer bottle
....


- Dan
 
Last edited:
I thought it had cats? by the way...my hub was worn and the bearing was bad...found the last hub in the bay area at sunnyvale ford and no more vibration :)
 
oh yeah...if you help me install a FMIC with welded piping I might donate my raised SC top, IC piping, and Ken Wagner DIC...all that looks pretty stock
 
oh yeah...if you help me install a FMIC with welded piping I might donate my raised SC top, IC piping, and Ken Wagner DIC...all that looks pretty stock

If its mild steel maybe .. my welders a little big for that at 220 .. dont have a TIG welder.

Yeah, no cats. There are a lot more parts I forgot to list - like ALL of the BOLTS ... LOL

Long time Jose, good to know some of the locals are still around. :)

- Dan
 
I think it is 2.75" mild steel...I'm hoping to use some of the old FMIC piping i had done plus maybe pick up a few u bends from ebay for $15
 
Maybe we can work something out .. you dont mean butt welds, but like pipes that fit over eachother right ?


- Dan
 
Back
Top