shoalcracker
Registered User
With a foot of snow arriving this week I thought about upgrades.
Pulled this off Charles site to compare what I had accomplished.
DD did similar back I think 07-08 and wanted to bring forward for others.
Kinda like Damons Rim Annual
Stage I
Exhaust
: Dual 2 ½" exhaust, or
Dual 2 ½" to single 3 ½" to Dual 2 x 2 ½"
Intake
: Magnum Powers MP Extreme (MPx) Supercharger w/ Intake Plenum
Magnum Powers 85mm Throttle Body
Magnum Powers Cold Air Intake
C&L 85mm MAF (Requires custom tune)
Intercooler
:Stock Intercooler with Fan
Engine
: Stock Heads
Stock Cam
42 pound Fuel Injectors
Motorcraft Sparkplugs gapped at .032"
Magnum Powers 10 rib 15% SC/JS Pulley Kit
MP Belt Tensioner Springs on upper and lower belts
Chassis
:195LPH Fuel Pump
Expected HP
:310rwhp/360rwtq
My build
Exhaust
Same as above
Intake
S Port
MP Plenum
Stock Intake
70 Maf -73 TB
No tune
Rich enough to cover computer and printer with plastic
(it was spewing)
Intercooler
KW Dbl with fan
Engine
Ported Heads
520 Cam with 1.8 Rockers
42 lb injectors
Plugs gapped at 43
Approx 15% overdrive
Tensioners
Chassis
195 LPH Pump
HP
Dyno 305-375
I know this is 4-5 yrs old technically but thought I would give it a shot.
Any current wins and losses. (past-present)
Paul
Pulled this off Charles site to compare what I had accomplished.
DD did similar back I think 07-08 and wanted to bring forward for others.
Kinda like Damons Rim Annual
Stage I
Exhaust
: Dual 2 ½" exhaust, or
Dual 2 ½" to single 3 ½" to Dual 2 x 2 ½"
Intake
: Magnum Powers MP Extreme (MPx) Supercharger w/ Intake Plenum
Magnum Powers 85mm Throttle Body
Magnum Powers Cold Air Intake
C&L 85mm MAF (Requires custom tune)
Intercooler
:Stock Intercooler with Fan
Engine
: Stock Heads
Stock Cam
42 pound Fuel Injectors
Motorcraft Sparkplugs gapped at .032"
Magnum Powers 10 rib 15% SC/JS Pulley Kit
MP Belt Tensioner Springs on upper and lower belts
Chassis
:195LPH Fuel Pump
Expected HP
:310rwhp/360rwtq
My build
Exhaust
Same as above
Intake
S Port
MP Plenum
Stock Intake
70 Maf -73 TB
No tune
Rich enough to cover computer and printer with plastic
(it was spewing)
Intercooler
KW Dbl with fan
Engine
Ported Heads
520 Cam with 1.8 Rockers
42 lb injectors
Plugs gapped at 43
Approx 15% overdrive
Tensioners
Chassis
195 LPH Pump
HP
Dyno 305-375
I know this is 4-5 yrs old technically but thought I would give it a shot.
Any current wins and losses. (past-present)
Paul