Anyone know of any good cylinder head spacer shims?

quatrini

Registered User
Hey guys had my block decked .010 and my heads .008
Also running wiseco pro-tru pistons at 9.0:1 compression, cam and 15% overdrive.
My question is does anyone think the resurfacing will cause problems with the raised compression ratio under full boost?
 
Hey guys had my block decked .010 and my heads .008
Also running wiseco pro-tru pistons at 9.0:1 compression, cam and 15% overdrive.
My question is does anyone think the resurfacing will cause problems with the raised compression ratio under full boost?

No, I run 10.0:1 comperssion block and heads both decked MLS gaskets MPX blower 30% od guessing 19+ psi boost (boost gauge messed up) made 5 back to back 1/4 passes with out stopping at all last time out last year.
 
you want to keep quench, unless you have reversed dome pistons. MLS gaskets have a higher compression height then Fel-Pro regular gaskets.
 
I have 98 mustang mls gaskets but they are made by fel pro. Are these mls gaskets thicker, thinner or the same?
Buy okay i guess ill be alright. Im runnng 15% od and looking at maybe 9.4:1
 
Back
Top