114mm bolt patern conversion

so I have a set of Mustang rims I want to use and here's what I'm planning I want to know if it'll work.

1994 - 2004 Mustang front hubs
http://www.ebay.com/itm/271418123235

1994 - 1998 Mustang rotors (front and rear)
http://www.ebay.com/itm/121208630072

For the rear hubs Im going to drill the 114 bolt pattern. I decided to replace the front ones because they are fairly cheap but I can drill the stock ones if these wont work. also the car is a 1990 I know the spindles are different from the latter years but im keeping the factory calipers for now if they'll work.

Mustang rear rotors won't work. You will need to either re-drill your stock rotors, or upgrade to 99-04 Cobra rear rotors, which will require you to also switch to the 93+ tbird rear calipers and get a set of adapter plates to relocate the caliper.

you will have to redrill the front hubs. the mustang front hubs only fit the 93+ front spindles, which you would have to change your calipers too.

thanks for the input looks like im just going to drill what i have until im ready to upgrade the brakes.

You don't have to change the rotors, just grind the wheel stud hole 1/4" and be done.

The center of the rotor will make it line up like a with no issues.

Unless you own the machine shop.

I work at a machine shop. I would rather drill the hubs and rotors. all 4 rotors need replacement. thought i could save time using mustang rotors.