Alright guys so i have finally swapped the motor over in the supercoupe! All vacuum lines seem okay, the installation looks neat and tidy, the car is ready to go!
Or not, no start. The motor turns over but has absolutely no signs of starting up.
I have tried pulling codes from the car, it gives me nothing. Here is what i have so far!
Fuel pump primes fine. Tried to fire using easy start and got nothing. Coil pack and wires are plugged in their respective positions. Fuses are okay. The ignition harness is all plugged in tightly and in the correct places. 2 engine grounds have been bolted back to their original places on the new motor.
I have a suspicion it has something to do with the crank position sensor as the plug was damaged on the new engine during transit, and damaged wiring on the old motor during removal. Neither of these seem to change anything.
Before i drop coin on a new sensor, is there anything i may be overlooking? Even with no codes, could this sensor still be at fault?
Neill
Or not, no start. The motor turns over but has absolutely no signs of starting up.
I have tried pulling codes from the car, it gives me nothing. Here is what i have so far!
Fuel pump primes fine. Tried to fire using easy start and got nothing. Coil pack and wires are plugged in their respective positions. Fuses are okay. The ignition harness is all plugged in tightly and in the correct places. 2 engine grounds have been bolted back to their original places on the new motor.
I have a suspicion it has something to do with the crank position sensor as the plug was damaged on the new engine during transit, and damaged wiring on the old motor during removal. Neither of these seem to change anything.
Before i drop coin on a new sensor, is there anything i may be overlooking? Even with no codes, could this sensor still be at fault?
Neill