1995 5-speed runs fine, many extras

Gdbnet

Registered User
Anyone interested in a '95 5-speed before I offload it elsewhere? It runs fine, but idle takes a bit to kick down for some reason (vacuum leak?) I ran out of time and need to move. Engine still very strong.

Extras:
SCP 3" Fresh Air Intake, C&L 73mm MAFS with sampling tube for stock injectors, set of larger injectors with matching sampling tube (not installed), 75mm throttle body, screamin' demon coil pack, LiveWires plug wires, Magnum Powers big bore throat SC intake, SCP 3" hi-flow exhaust, headers, new battery, new motor mounts, B&M Ripper short throw shifter, SPEC stage 1 high performance clutch & rebuilt transmission.

I have the original intake/MAFS/throttle body/SC intake

Interior is pretty decent... carpet is great, leather has a couple of obligatory leather seam issues.
Paint is showing it's age.

$2500 in Annapolis, MD
 

Attachments

  • image021.jpg
    image021.jpg
    77.3 KB · Views: 881
  • image015.jpg
    image015.jpg
    75.9 KB · Views: 891
  • image030.jpg
    image030.jpg
    56 KB · Views: 887
  • image027.jpg
    image027.jpg
    43.7 KB · Views: 876
  • image029.jpg
    image029.jpg
    42.7 KB · Views: 886
Additional Engine photos
 

Attachments

  • image019.jpg
    image019.jpg
    62.4 KB · Views: 881
  • image020.jpg
    image020.jpg
    64.8 KB · Views: 881
  • image018.jpg
    image018.jpg
    75 KB · Views: 896
  • image016.jpg
    image016.jpg
    60.1 KB · Views: 890
  • image017.jpg
    image017.jpg
    70.8 KB · Views: 888
Additional photos showing paint & leather seams
 

Attachments

  • image032.jpg
    image032.jpg
    65.1 KB · Views: 888
  • image025.jpg
    image025.jpg
    43.7 KB · Views: 877
  • image024.jpg
    image024.jpg
    51.1 KB · Views: 887
  • image023.jpg
    image023.jpg
    53.2 KB · Views: 862
  • image022.jpg
    image022.jpg
    55.8 KB · Views: 877
175k. Email barnettgd at gmail dot com and I can send phone # etc.

Update on "Runs fine" The engine is strong, but after doing a check-out i'm trying to fix an oil leak from the oil pump gasket where it seals to the engine. Just replaced the oil cooler gasket which was needed (and much easier). Oil pump is good, but it appears to have gotten loose. (and I think I found the original gasket in the oil cooler :-D).

Greg
 
Oil leak fixed (oil sender) and also rebuilt oil pump, new seal on oil cooler, and replaced camshaft synchronizer. Oil system is all good, and it runs strong again!
 
Back
Top